IECEx CoC Home > Certified Equipment Scheme > Certificate of Conformity
important information !
an IECEx Guest User | ExCB Login

IECEx Certificate
of Conformity
 
INTERNATIONAL ELECTROTECHNICAL COMMISSION
IEC Certification Scheme for Explosive Atmospheres
for rules and details of the IECEx Scheme visit www.iecex.com
 
Certificate No.:
IECEx SIR 12.0026X issue No.:0
 
Status:
Current
 
Date of Issue:2012-06-13 Page 1 of 4


    
Applicant:
Orga B.V.
Strickledeweg 13
3125 AT Schiedam
The Netherlands


 
Electrical Apparatus:L85EX-x-xx-xx Range of LED Lighting Fixtures
Optional accessory:


 
Type of Protection:Increased Safety and Encapsulation


 
Marking:

Ex e mb IIC T4 Gb
(Ta = -50°C to +40°C) or (Ta = -50°C to +45°C) – See Description of Equipment

 
Approved for issue on behalf of the IECEx
Certification Body:		C Ellaby

 
Position:Deputy Certification Manager


 
Signature:
(for printed version)
 
Date:
 
 
1. This certificate and schedule may only be reproduced in full.
2. This certificate is not transferable and remains the property of the issuing body.
3. The Status and authenticity of this certificate may be verified by visiting the Official IECEx Website.
 
 Certificate issued by:
SIRA Certification Service
Rake Lane
Eccleston
Chester
CH4 9JN
United Kingdom


- PAGE BREAK -

IECEx Certificate
of Conformity
 
Certificate No.:IECEx SIR 12.0026X
 
Date of Issue:2012-06-13Issue No.: 0
 
Page 2 of 4
 
 Manufacturer:
Orga B.V.
Strickledeweg 13
3125 AT Schiedam
The Netherlands


 
 Additional Manufacturing location(s):
 

This certificate is issued as verification that a sample(s), representative of production, was assessed and tested and found to comply with the IEC Standard list below and that the manufacturer's quality system, relating to the Ex products covered by this certificate, was assessed and found to comply with the IECEx Quality system requirements. This certificate is granted subject to the conditions as set out in IECEx Scheme Rules, IECEx 02 and Operational Documents as amended.


STANDARDS:
The electrical apparatus and any acceptable variations to it specified in the schedule of this certificate and the identified documents, was found to comply with the following standards:

 
IEC 60079-0 : 2007-10
Edition: 5		Explosive atmospheres - Part 0:Equipment - General requirements
IEC 60079-18 : 2009
Edition: 3		Explosive atmospheres Part 18: Equipment protection by encapsulation "m"
IEC 60079-7 : 2006-07
Edition: 4		Explosive atmospheres - Part 7: Equipment protection by increased safety "e"
 
This Certificate does not indicate compliance with electrical safety and performance requirements other than those expressly included in the Standards listed above.


 
TEST & ASSESSMENT REPORTS:A sample(s) of the equipment listed has successfully met the examination and test requirements as recorded in

 
Test Report:
GB/SIR/ExTR12.0135/00


Quality Assessment Report:

NL/KEM/QAR08.0002/02


- PAGE BREAK -

IECEx Certificate
of Conformity
 
Certificate No.:IECEx SIR 12.0026X
 
Date of Issue:2012-06-13Issue No.: 0
 
Page 3 of 4
 
 
Schedule
 
EQUIPMENT:
Equipment and systems covered by this certificate are as follows:
 

The Lighting Fixture range L85EX-x-xx-xx is designed as a range of warning and signal beacons.  The construction of the L85EX consists of a rectangular stainless steel body with non-metallic dome and clamping ring.  Four mounting feet are formed as part of the base for floor mounting.  The L85EX consists of an encapsulated power supply mounted within the metallic body with increased safety terminals and an increased safety LED light engine.  The cover of the main body is secured with four screws and the clamping ring is retained with a further four screws.  External connection to the device is through two off cable entries located in the base which may be M16, M20, M25, ½” NPT or 3/8” NPT.

 

Electrical data - Power supply to L85EX: 100-254 V a.c. 50-60Hz

 

Temperature ranges - The L85EX have the following temperature ranges:

ArrangementTemp. rangeArrangementTemp. range
Red LEDs up to 260 mA-50°C to +45°CBlue LEDs up to 140 mA-50°C to +45°C
Red LEDs up to 385 mA-50°C to +40°CWhite LEDs up to 140 mA-50°C to +45°C
Green LEDs up to 140 mA-50°C to +45°CYellow LEDs up to 260 mA-50°C to +45°C
 
CONDITIONS OF CERTIFICATION: YES as shown below:
 

1.

The L85EX shall only be used in locations where there is a low risk of mechanical impact.
 


- PAGE BREAK -

IECEx Certificate
of Conformity
 
Certificate No.:IECEx SIR 12.0026X
 
Date of Issue:2012-06-13Issue No.: 0
 
Page 4 of 4
 
 
EQUIPMENT(continued):
 
Conditions of manufacture
The Manufacturer shall comply with the following:
1. A visual inspection of the encapsulation is to be completed; no damage such as cracks, exposure of encapsulated parts, flaking, inadmissible shrinkage, swelling, decomposition failure of adhesion or softening shall be evident.
2.The dielectric strength test according to IEC 60079-18:2009 clause 8.2.4 shall be applied to the power supply for at least 1 second on the power supply, the test voltage shall be at least 1620 V d.c.. Alternatively, 1.2 x test voltage may be applied and maintained for at least 100 ms.
3.The dielectric strength test according to IEC 60079-7:2006 clause 6.1 shall be applied to the light engine for at least 60 seconds, the test voltage shall be at least 500 V d.c.. Alternatively, 1.2 x test voltage may be applied and maintained for at least 100 ms.
 
 
 







Copyright © IEC-IECEx 2013 , Geneva Switzerland. All rights reserved.