Certificate history:
Ex ib IIC T4 Gb (-20°C ≤ Ta < +55°C)Ex ib IIIC T90°C Db (-20°C ≤ Ta < +55°C)
This certificate is issued as verification that a sample(s), representative of production, was assessed and tested and found to comply with the IEC Standard list below and that the manufacturer's quality system, relating to the Ex products covered by this certificate, was assessed and found to comply with the IECEx Quality system requirements. This certificate is granted subject to the conditions as set out in IECEx Scheme Rules, IECEx 02 and Operational Documents as amended.
This Unit verification certificate is issued as verification that the Apparatus identified on page 1, was assessed and tested and found to comply with the IEC Standard list below. This certificate is granted subject to the conditions as set out in IECEx Scheme Rules, IECEx 02 and Operational Documents as amended.
STANDARDS: The electrical apparatus and any acceptable variations to it specified in the schedule of this certificate and the identified documents, was found to comply with the following standards:
As this is a Unit Verification Certificate, no QAR is applicable as this certificate is specific to the items listed by serial number or other unique identification.
The STP8X series TETRA Radio is a hand-held radio commonly used by the emergency services, oil, gas, transport and utility companies for 2-way radio communications.It consists of a single multi-layer PCB with connections to the keypad; display; antenna; Bluetooth module, GPS/Man Down Module, SIM card, SD card and replaceable battery pack including battery protection PCB all contained within a plastic enclosure.The radio is charged up by inserting the radio into either the STP8X Desktop charger or STP8X In-Car charger when located in the non-hazardous area. Connections to the following accessories is made via the rugged side connector. The connection or disconnection of any accessory connected directly to the rugged side connector may only be done in the non-hazardous area:
• USB Programming Lead, covered by certificate number IECEx VTT 11.0007X.
For the list of non-electrical accessories, see Annex.
1. The equipment was impact tested according to the low risk of mechanical danger and must be protected accordingly against high level of impact.2. The Battery Pack, Antenna, RuSC cover or RuSC connector must not be removed in the hazardous area.
