Ex db IIC Gb Ex tb III C Db Ta = -40°C to +60°C
This certificate is issued as verification that a sample(s), representative of production, was assessed and tested and found to comply with the IEC Standard list below and that the manufacturer's quality system, relating to the Ex products covered by this certificate, was assessed and found to comply with the IECEx Quality system requirements. This certificate is granted subject to the conditions as set out in IECEx Scheme Rules, IECEx 02 and Operational Documents as amended.
This Unit verification certificate is issued as verification that the Apparatus identified on page 1, was assessed and tested and found to comply with the IEC Standard list below. This certificate is granted subject to the conditions as set out in IECEx Scheme Rules, IECEx 02 and Operational Documents as amended.
The apparatus and any acceptable variations to it specified in the schedule of this certificate and the identified documents, was found to comply with the following standards:
As this is a Unit Verification Certificate, no QAR is applicable as this certificate is specific to the items listed by serial number or other unique identification.
The 9080 series dual compartment housings are cylindrical, comprising a base and two covers with an approximate internal volume of 450 cm³. The two compartments are separated by a central internal wall that may have one 8 mm thru hole for electronics. The electronics are secured with epoxy cement. The enclosures are manufactured from Copper-free Aluminium or Stainless Steel, the Copper-free Aluminium versions have an epoxy paint coating of maximum thickness 0.20 mm. The covers are either manufactured from Aluminium or Stainless Steel, and may be blind or comprise a tempered glass window. The housings meet the requirements for degree of protection IP68. The housings can be populated with either a four post terminal block or a ten post semi-circle terminal block as specified in the manufacturer’s documents. Refer to the Annexe for Further information, including the Schedule of Limitations.
This issue, Issue 1, recognises the following changes;