Certificate history:
This certificate is issued as verification that a sample(s), representative of production, was assessed and tested and found to comply with the IEC Standard list below and that the manufacturer's quality system, relating to the Ex products covered by this certificate, was assessed and found to comply with the IECEx Quality system requirements. This certificate is granted subject to the conditions as set out in IECEx Scheme Rules, IECEx 02 and Operational Documents as amended.
This Unit verification certificate is issued as verification that the Apparatus identified on page 1, was assessed and tested and found to comply with the IEC Standard list below. This certificate is granted subject to the conditions as set out in IECEx Scheme Rules, IECEx 02 and Operational Documents as amended.
STANDARDS: The electrical apparatus and any acceptable variations to it specified in the schedule of this certificate and the identified documents, was found to comply with the following standards:
As this is a Unit Verification Certificate, no QAR is applicable as this certificate is specific to the items listed by serial number or other unique identification.
A range of compression type cable glands manufactured in brass, stainless steel or aluminium. The glands may be supplied with metric or specified non-metric equivalent thread forms. These glands are intended for use with effectively filled circular cables. The cable type and/or cable protection/retention method is specific to each gland type designation – see annex for detail.
1. These glands are suitable for use within an operating temperature range of -60oC to +80oC, or +100oC for the gland types not using the iris type outer seal assembly.2. When the gland is used for increased safety or dust protection, the entry thread shall be suitably sealed in accordance with IEC 60079-14 to maintain the ingress protection rating of the associated enclosure3. Glands for use with conduit, unarmoured or braided cables are only suitable for fixed installations, the cable for which must be effectively clamped to prevent pulling and twisting (does not apply to variation 6.3).
Variation 6.1To allow the replacement of the 7o armour clamping components with 5o armour clamping components on gland sizes Os, O and A.Variation 6.2The introduction of a range of non reversible dedicated armour clamping rings, in this form the RAC stamping is replaced by DED followed by W, X, Y or Z to indicate the type of armour that may be fitted.Variation 6.3To allow the introduction of a rear clamping mechanism to the 501/421 gland size B, in this form the gland is designated 501/421R.For variation 6.3 Condition of Cetification No. 3 does not apply.
