This certificate is issued as verification that a sample(s), representative of production, was assessed and tested and found to comply with the IEC Standard list below and that the manufacturer's quality system, relating to the Ex products covered by this certificate, was assessed and found to comply with the IECEx Quality system requirements. This certificate is granted subject to the conditions as set out in IECEx Scheme Rules, IECEx 02 and Operational Documents as amended.
This Unit verification certificate is issued as verification that the Apparatus identified on page 1, was assessed and tested and found to comply with the IEC Standard list below. This certificate is granted subject to the conditions as set out in IECEx Scheme Rules, IECEx 02 and Operational Documents as amended.
The electrical apparatus and any acceptable variations to it specified in the schedule of this certificate and the identified documents, was found to comply with the following standards:
As this is a Unit Verification Certificate, no QAR is applicable as this certificate is specific to the items listed by serial number or other unique identification.
The T206 Potash Monitor is designed to measure and display the level of radiation detected by an external probe containing a Geiger Muller tube.The Monitor contains an encapsulated signal Interface Module, Processor/Display PCB and replaceable battery, housed in a hand held moulded plastic case. The battery compartment is secured with a special fastener and the battery must only be changed in the non hazardous area; a suitable warning is moulded into the battery cover. The battery is connected using an industry standard connector. The external probe contains an encapsulated HT Module and a Geiger Muller tube. The maximum length of the cable connected to the probe is 35 metres.On the rear of the main enclosure is an integral IP65 connector for connection to the external probe.