Certificate history:
This certificate is issued as verification that a sample(s), representative of production, was assessed and tested and found to comply with the IEC Standard list below and that the manufacturer's quality system, relating to the Ex products covered by this certificate, was assessed and found to comply with the IECEx Quality system requirements. This certificate is granted subject to the conditions as set out in IECEx Scheme Rules, IECEx 02 and Operational Documents as amended.
This Unit verification certificate is issued as verification that the Apparatus identified on page 1, was assessed and tested and found to comply with the IEC Standard list below. This certificate is granted subject to the conditions as set out in IECEx Scheme Rules, IECEx 02 and Operational Documents as amended.
STANDARDS: The electrical apparatus and any acceptable variations to it specified in the schedule of this certificate and the identified documents, was found to comply with the following standards:
As this is a Unit Verification Certificate, no QAR is applicable as this certificate is specific to the items listed by serial number or other unique identification.
A Type ICF-CHKRWXD11, 400H Frame, 4 Pole, Induction Motor rated at 450kW, 6600V, 60Hz. The motor has a cooling fan attached at the non-drive end protected by a steel cowl, and is fitted with three separate terminal boxes of differing sizes to accommodate the electrical connections to the stator windings, an internal space heater and a series of RTDs to monitor and detect excessive stator winding temperatures.Thermal monitoring of the shaft bearings at each end of the machine is provided by the fitment of separately certified RTD assemblies to IECEx BAS 08.0094X. Cable entry holes are provided as specified on the certified drawings for the accommodation of flameproof cable entry devices, with or without the interposition of a flameproof thread adapter. Unused entries are to be fitted with suitable certified flameproof stopping plugs. The cable entry devices, thread adapters and stopping plugs shall be suitable for the equipment, the cable and the conditions of use and shall be separately certified as Equipment (not a Component).The motor is rated for S1 duty (continuous) when connected to a 3 phase, sinusoidal, 60Hz supply having form and symmetry not worse than that defined in IEC 60034-1.
