Ex ib IIC T4 GbEx ib III C T135°C Db IP6X
This certificate is issued as verification that a sample(s), representative of production, was assessed and tested and found to comply with the IEC Standard list below and that the manufacturer's quality system, relating to the Ex products covered by this certificate, was assessed and found to comply with the IECEx Quality system requirements. This certificate is granted subject to the conditions as set out in IECEx Scheme Rules, IECEx 02 and Operational Documents as amended.
This Unit verification certificate is issued as verification that the Apparatus identified on page 1, was assessed and tested and found to comply with the IEC Standard list below. This certificate is granted subject to the conditions as set out in IECEx Scheme Rules, IECEx 02 and Operational Documents as amended.
The apparatus and any acceptable variations to it specified in the schedule of this certificate and the identified documents, was found to comply with the following standards:
As this is a Unit Verification Certificate, no QAR is applicable as this certificate is specific to the items listed by serial number or other unique identification.
The intrinsically safe 3G mobile phone ADVANTAGE in the variants 1.0 and 1.1 is designed for communications in explosion hazardous areas of zones 1, 2, 21 and 22. It is equipped with camera (only type 1.0), Bluetooth, GPS, PTT, optional lone worker protection, and vibration alert.The permitted ambient temperature is -20°C to +60°C.The power supply of the mobile phone consists of a battery pack mounted on the back of the phone. The battery pack contains a Li-ion cell and a current and power-limiting safety circuit. The battery pack is charged, without being removed, via a USB jack in the base unit or charging contacts at the side of the phone.
Electrical data, power supply: The mobile phone may only be used with the intrinsically safe battery pack BPA01A made by i.safe MOBILE GmbH.U0 = 3,8 V (U0_max = 4,2V)I0 = 1,2 A P0 = 4,56 W
Electrical data, Interface: USB interface for charging and data transfer, charging contacts at the sides of the phone. Connection is only allowed outside ex-hazardous areas and only with the i.safe MOBILE i.safe PROTECTOR USB-cable or other accessories specified by i.safe MOBILE GmbH.
The battery pack may be changed or charged outside ex-hazardous areas only. The test for impact according to EN60079-0 Clause 26.4.2 was done only with low impact energy. The device must be protected from impacts with high impact energy.The permitted ambient temperature is -20°C to +60°C.