This certificate is issued as verification that a sample(s), representative of production, was assessed and tested and found to comply with the IEC Standard list below and that the manufacturer's quality system, relating to the Ex products covered by this certificate, was assessed and found to comply with the IECEx Quality system requirements. This certificate is granted subject to the conditions as set out in IECEx Scheme Rules, IECEx 02 and Operational Documents as amended.
This Unit verification certificate is issued as verification that the Apparatus identified on page 1, was assessed and tested and found to comply with the IEC Standard list below. This certificate is granted subject to the conditions as set out in IECEx Scheme Rules, IECEx 02 and Operational Documents as amended.
The electrical apparatus and any acceptable variations to it specified in the schedule of this certificate and the identified documents, was found to comply with the following standards:
As this is a Unit Verification Certificate, no QAR is applicable as this certificate is specific to the items listed by serial number or other unique identification.
Variation 1.1To permit minor changes to the printed circuit board that do not affect the original assessment.Variation 1.2To confirm that the equipment covered by this certificate has been reviewed against the requirements of IEC 60079-0:2007 and IEC 60079-11:2011 in respect of the differences from IEC 60079-0:2004 and IEC 60079-11:2006 and that none of these differences, with the exception of marking, affect this equipment. The equipment is now marked:[Ex ia Ga] IIC[Ex ia Da] IIIC[Ex ia Ma] I