Certificate history:
This certificate is issued as verification that a sample(s), representative of production, was assessed and tested and found to comply with the IEC Standard list below and that the manufacturer's quality system, relating to the Ex products covered by this certificate, was assessed and found to comply with the IECEx Quality system requirements. This certificate is granted subject to the conditions as set out in IECEx Scheme Rules, IECEx 02 and Operational Documents as amended.
This Unit verification certificate is issued as verification that the Apparatus identified on page 1, was assessed and tested and found to comply with the IEC Standard list below. This certificate is granted subject to the conditions as set out in IECEx Scheme Rules, IECEx 02 and Operational Documents as amended.
STANDARDS: The electrical apparatus and any acceptable variations to it specified in the schedule of this certificate and the identified documents, was found to comply with the following standards:
As this is a Unit Verification Certificate, no QAR is applicable as this certificate is specific to the items listed by serial number or other unique identification.
The BPG range of Control Stations comprise of polyester enclosures that are fitted with an arrangement of IECEx certified ammeters, switches, signal lamps and terminals. All enclosures are fitted with gaskets of substantially round cross section, closed cell polychloroprene or closed cell silicone rubber. The enclosure lid can be populated with switch operators, lamp bezels or 4mm thick glass windows as specified on the associated certification drawings. Tapped or clearance hole entries may be provided through the side walls or the rear of the box. When unused the entries will be blanked off with IECEx metal blanking plugs and sealing washers or O-rings suitable for the ingress protection provided by the enclosure.
1.
Issue 1 – this Issue introduced the following changes:
1
Report number R51A20310B replaced R51A20310A.
